ONE COMPONENT SELF-ETCHING ADHESIVE AGENT MDP & 4-META 7th GENERATION COMPO B PLUS is an innovative, one-component, self-etching ethanol/water solution adhesive agent. It can be used with total-etch and selective-etch techniques, as well as direct placement for direct and indirect restorations. INDICATIONS Bonding of composite resins without primer Bonding of all-ceramic and zirconia restorations As an adhesive agent with dual-curing resin cements As a desensitizing agent due to low pH value. For bonding Sealand-type resins For bonding fiberglass or metal posts. As a waterproofing material for glass ionomer fillings. As a metal primer for repairing fractured resin-ceramic or resin-resin restorations. INNOVATION 1: (10-MDP) is an innovative monomer that provides: Higher adhesion values to enamel Increases self-etching ability Greater bond strength in wet environments Greater cohesive strength for metallic surfaces Even for implant abutments INNOVATION 2: (4-META) is an innovative monomer that provides: High shear bond strength values Creation of organic chains through hydroxyapatite molecules. Bond strength through carboxylated dimethacrylate monomer in a wet environment. ADVANTAGES 1)The low pH allows mild penetration into the dentinal tubules and no postoperative sensitivity. 2)Suitable for the minimal invasive restoration technique for restoring facets of fillings and endodontically for post bonding. 3)One component. No separate mixing of components is required. 4)Strong shear bond. 5) Double adhesion bond due to the presence of two organic monomers. 6) Contains the innovative MDP monomer which adheres to hydroxyapatite prisms through covalent calcium carbonate bonds, imparting high bond strength to the hybrid layer. 7) The second organic monomer is 4-META, which has hydrophilic behavior, diffuses deep into the dentinal tubules in wet dentin, and acts as an inhibitor to the hydrolysis of the hybrid layer. Packaging: 1 x 5ml Vial, 50 Application Tips 25 Mixing Pads 1 x Instructions for Use TECHNICAL INFORMATION: Photopolymerization time: 20 sec Adhesion strength: 17 MPa PH 2.8